LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Overhaul - Coupe) >> Input Shaft >> Disassembly And Assembly >> Assembly Service Points >> >> E << Synchronizer Ring Installation

>> E << Synchronizer Ring Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: There are 3rd speed and 4th speed synchronizer rings, if the wrong one is installed it will effect the shift feeling.
  1. Ascertain whether or not there are identification notches on the synchronizer ring.

    Two notches: 3rd speed synchronizer ring 

    No notches: 4th speed synchronizer ring 

  2. Install the synchronizer ring so that it does not angle to the cone of the gear.
    Fig 1: Identifying Notch
    G04541619Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals