<< H >> Engine Assembly Support

WARNING: This page is about a different car, the 2005 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.

< Engine lifter MZ203827 is used >
Set special tool MB991453 and MZ203827 to the vehicle to support the engine assembly.

Fig 1: Supporting Engine Assembly Using Special Tool MB991453 And MZ203827
Courtesy of DAIMLERCHRYSLER CORPORATION
< Engine hanger MB991895 is used >
1. Set special tool MB991895 to the front fender mounting bolts (A and B) and the radiator support upper insulator mounting bolts (C and D), which are located in the engine compartment, as shown in figure.
  
  Fig 2: Locating Front Fender And Radiator Support Upper Insulator Mounting Bolts
  Courtesy of DAIMLERCHRYSLER CORPORATION
2. Set special tool MB991454 to hold the engine/transaxle assembly.
  
  Fig 3: Holding Engine/Transaxle Assembly Using Special Tool MB991454
  Courtesy of DAIMLERCHRYSLER CORPORATION
< Engine hanger MB991928 is used >
1. Assemble the engine hanger (special tool MB991928). Set following parts to the base hanger.
  - Slide bracket (HI)
  - Foot (standard) (MB991932)
  - Foot (short) (MB991933)
  - Joint (50) (MB991929)
  - Joint (90) (MB991930)
  - Joint (140) (MB991931)
    
    Fig 4: Assembling Engine Hanger (Special Tool MB991928)
    Courtesy of DAIMLERCHRYSLER CORPORATION
2. Set the engine hanger (special tool MB991928) to the front fender mounting bolts (A and B) and the radiator support upper insulator mounting bolts (C and D), which are located in the engine compartment, as shown in figure.
  NOTE: Adjust the engine hanger balance by sliding the slide bracket (HI).
  
  Fig 5: Locating Fender Mounting And Radiator Support Upper Insulator Mounting Bolts
  Courtesy of DAIMLERCHRYSLER CORPORATION
3. Set special tools MB991454 to hold the engine/transaxle assembly.
  
  Fig 6: Holding Engine/Transaxle Assembly Using Special Tools MB991454
  Courtesy of DAIMLERCHRYSLER CORPORATION