LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (On-Vehicle Service - Coupe) >> Transaxle Assembly >> Removal And Installation >> Removal Service Points >> << F >> Driveshaft And Inner Shaft Disconnection

<< F >> Driveshaft And Inner Shaft Disconnection

WARNING: This page is about a different car, the 2005 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not damage the transaxle oil seal with the spline of the inner shaft.
  1. If the inner shaft and transaxle are tightly joined, tap the center bearing bracket lightly with a plastic hammer to remove the driveshaft and inner shaft from the transaxle.
  2. Cover the transaxle case with a shop towel to prevent foreign material from entering it.
    Fig 1: Removing Driveshaft And Inner Shaft
    G04541528Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals