LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (On-Vehicle Service - Coupe) >> Transaxle Assembly >> Removal And Installation >> Removal Service Points >> << E >> Driveshaft Disconnection

<< E >> Driveshaft Disconnection

WARNING: This page is about a different car, the 2005 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not pull on the driveshaft; doing so will damage the TJ; be sure to use a pry bar.
  • Do not insert a pry bar so deep as to damage the oil seal.
  • Do not damage the transaxle oil seal with the spline of the driveshaft.

Insert a pry bar between the transaxle case and the driveshaft as shown in figure to remove the driveshaft.

Fig 1: Inserting Pry Bar Between Transaxle Case And Driveshaft
G04541527Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals