LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Steering System - Coupe) >> Steering Wheel And Shaft Assembly >> Removal And Installation >> Installation Service Points >> >> B << Steering Cover Assembly Installation

>> B << Steering Cover Assembly Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Mount steering cover assembly in the steering gear box securely at the groove, so that the clearance A (shown in the illustration at left) will be at the standard value.

    Standard value (A): 0 - 0.5 mm (0 - 0.02 inch) 

    Fig 1: Mounting Steering Cover Assembly In Steering Gear Box
    G04539235Courtesy of DAIMLERCHRYSLER CORPORATION
  2. Before bolting, apply 3M(tm) Part number 8663 or equivalent to the mounting bolt holes of toeboard.
    Fig 2: Applying 3M(tm) To Mounting Bolt Holes Of Toeboard
    G04539236Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals