LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Steering System - Coupe) >> Power Steering Gear Box Assembly >> Disassembly And Assembly >> Lubrication And Sealing Points >> Assembly Service Points >> >> D << Rack Installation

>> D << Rack Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not close the vent hole in the rack with grease.
  1. Apply a coating of MOPAR(R) Multi-mileage Lubrication Part No. 2525035 or equivalent to the rack teeth face.
    Fig 1: Applying Coating Of Multi-Mileage Lubrication To Rack Teeth Face
    G04539263Courtesy of DAIMLERCHRYSLER CORPORATION
  2. Cover rack serrations with special tool MB991213.
  3. Apply DIAMOND ATF to special tool MB991213.
  4. Align the center of the oil seal with the rack to prevent the retainer spring from slipping. Slowly insert the rack from power cylinder side.
    Fig 2: Covering Rack Serrations With Special Tool
    G04539264Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals