Fastener Tightening Specification
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
FASTENER TIGHTENING SPECIFICATION
| ITEM | SPECIFICATION |
|---|---|
| Centermember front mounting bolt | 93 +/- 15 N.m (69 +/- 11 ft-lb) |
| Centermember rear mounting bolt | 74 +/- 4 N.m (55 +/- 3 ft-lb) |
| Crossmember and stay connecting bolt < 2.4L ENGINE > | 74 +/- 4 N.m (55 +/- 3 ft-lb) |
| Crossmember mounting bolt | 108 +/- 10 N.m (80 +/- 7 ft-lb) |
| Crossmember mounting nut | 88 +/- 10 N.m (65 +/- 7 ft-lb) |
| Dynamic damper bolt | 4.9 +/- 1.0 N.m (44 +/- 8 in-lb) |
| Engine mount bracket bolt | 86 +/- 12 N.m (64 +/- 8 ft-lb) |
| Engine mount bracket nut | 86 +/- 12 N.m (64 +/- 8 ft-lb) |
| Engine mount insulator mounting bolt | 81 +/- 12 N.m (60 +/- 9 ft-lb) |
| Engine mount stay bolt < 3.0L ENGINE > | 36 +/- 6 N.m (27 +/- 4 ft-lb) |
| Lower arm and crossmember connecting nut | 108 +/- 10 N.m (80 +/- 7 ft-lb) |
| Lower arm clamp bolt | 81 +/- 12 N.m (60 +/- 9 ft-lb) |
| Transaxle and front roll stopper connecting bolt | 45 +/- 5 N.m (34 +/- 3 ft-lb) |
| Transaxle and front roll stopper connecting nut | 45 +/- 10 N.m (34 +/- 7 ft-lb) |
| Transaxle and rear roll stopper connecting bolt | 45 +/- 5 N.m (34 +/- 3 ft-lb) |
| Transaxle and rear roll stopper connecting nut | 45 +/- 5 N.m (34 +/- 3 ft-lb) |
| Transaxle mount bracket nut | 57 +/- 7 N.m (42 +/- 5 ft-lb) |
| Transaxle mount insulator mounting nut | 81 +/- 12 N.m (60 +/- 9 ft-lb) |