Crossmember Bushing C

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Use special tool MB990828 to drive out and press-fit the crossmember bushing C.

Fig 1: Removing Crossmember Bushing
Courtesy of CHRYSLER CORP.
The bushing should be press-fitted so that the inner pipe projection is at the standard length.
Standard value (A): 4.0 +/- 0.5 mm (0.16 +/- 0.02 inch)

Fig 2: Identifying Inner Pipe Projection Length
Courtesy of CHRYSLER CORP.