LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (3.0L Engine (Service Information) - Coupe) >> Crankshaft And Cylinder Block >> Removal And Installation >> Installation Service Points >> >> F << Oil Seal Case Assembly Installation

>> F << Oil Seal Case Assembly Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply sealant (MITSUBISHI Genuine Part number MD970389 or equivalent) to the gasket surface of oil seal case.
    NOTE: Be sure to install the case quickly while the sealant is wet (within 15 minutes).
  2. Apply engine oil to the lip of the oil seal, and then install the oil seal case onto the cylinder block.
    NOTE: After installation, keep the sealed area away from the oil for approximately one hour.
    Fig 1: Applying Sealant To Gasket Surface Of Oil Seal Case
    G04538507Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals