LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (3.0L Engine (Service Information) - Coupe) >> Crankshaft And Cylinder Block >> Removal And Installation >> Installation Service Points >> >> C << Crankshaft Thrust Bearing Installation

>> C << Crankshaft Thrust Bearing Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the thrust bearings in the number 3 bearing bore in the cylinder block and in the bearing cap. For easier installation, apply engine oil to the bearings; this will help hold them in position.
  2. The thrust bearings must be installed with their groove toward the crankshaft web. The two thrust bearings are different from each other. One has a tab while the other has no tab. Be careful not to confuse them.
    Fig 1: Installing Thrust Bearings
    G04538503Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals