LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (2.4L Engine (Service Information) - Coupe) >> Piston And Connecting Rod >> Removal And Installation >> Installation Service Points >> >> F << Connecting Rod Cap Installation

>> F << Connecting Rod Cap Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verifying the mark made during disassembly, install the bearing cap to the connecting rod. If the connecting rod is new with no index mark, make sure that the bearing locking notches are on the same side as shown.
    Fig 1: Installing Connecting Rod Cap
    G04538292Courtesy of DAIMLERCHRYSLER CORPORATION
  2. Make sure that the connecting rod big end side clearance meets the specification.

    Standard value: 0.10 - 0.25 mm (0.004 - 0.009 inch) Limit: 0.4 mm (0.015 inch) 

    Fig 2: Measuring Connecting Rod Big End Side Clearance
    G04538293Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals