LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (2.4L Engine (Service Information) - Coupe) >> Piston And Connecting Rod >> Removal And Installation >> Installation Service Points >> >> B << Oil Ring Installation

>> B << Oil Ring Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fit the oil ring spacer into the piston ring groove.
    NOTE: The side rails and spacer may be installed in either direction.
    NOTE: New spacers and side rails are colored for identification of their sizes.
    Fig 1: Fitting Oil Ring Spacer Into Piston Ring Groove
    G04538283Courtesy of DAIMLERCHRYSLER CORPORATION
    OIL RING DESCRIPTION

    SIZE IDENTIFICATION COLOR
    Standard None
    0.50 mm (0.020 in) oversize diameter Red
    1.00 mm (0.040 in) oversize diameter Yellow
    CAUTION: Do not use a piston ring expander when installing side rail.
  2. Install the upper side rail.

    To install the side rail, first fit one end of the rail into the piston groove, then press the remaining portion into position by finger. See Fig 2.

  3. Install the lower side rail in the same procedure as described in step  2.
  4. Make sure that the side rails move smoothly in both directions.
    Fig 2: Installing Lower Side Rail
    G04538284Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals