LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (2.4L Engine (Service Information) - Coupe) >> Front Case And Oil Pump >> Removal And Installation >> Installation Service Points >> >> I << Flange Bolt Installation

>> I << Flange Bolt Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Insert a Phillips head screwdriver [shank diameter 8 mm (0.3 inch)] into the hole in the left side of the cylinder block to lock the counterbalance shaft.
    Fig 1: Installing Flange Bolt Using Screw Driver
    G04538265Courtesy of DAIMLERCHRYSLER CORPORATION
  2. Secure the oil pump driven gear onto the left counterbalance shaft by tightening the flange bolt to the specified torque.

    Tightening torque: 36 +/- 3 N.m (27 +/- 2 ft-lb) 

  3. Pull out the screwdriver and screw in the plug.
    Fig 2: Tightening Flange Bolt
    G04538266Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals