LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (2.4L Engine (Service Information) - Coupe) >> Crankshaft And Cylinder Block >> Removal And Installation >> Installation Service Points >> >> E << Sealant Application To Oil Seal Case

>> E << Sealant Application To Oil Seal Case

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply the sealant (MITSUBISHI Genuine Part number MD970389 or equivalent) to the gasket surface of oil seal case.
    NOTE: Be sure to install the case quickly while the sealant is wet (within 15 minutes).
  2. Apply engine oil to the oil seal lip, and then install the oil seal case onto the cylinder block.
    NOTE: After installation, keep the sealed area away from the oil for approximately one hour.
    Fig 1: Applying Sealant Application To Oil Seal Case
    G04538311Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals