LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (2.4L Engine (Service Information) - Coupe) >> Crankshaft And Cylinder Block >> Removal And Installation >> Installation Service Points >> >> A << Crankshaft Thrust Bearing Installation

>> A << Crankshaft Thrust Bearing Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the two thrust bearings in the number 3 bearing bore in the cylinder block. For easier installation, apply engine oil to the bearings; this will help hold them in position.
  2. The thrust bearings must be installed with their groove side toward the crankshaft web.
    Fig 1: Installing Crankshaft Thrust Bearing
    G04538300Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals