How To Locate Wind Noise

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Attach cloth tape to every place, such as panel seams, projections, molding seams, glass and body seams, etc. which might conceivably be the source of wind noise.
Then make a road test to check that the places not covered by tape are not sources of wind noise.

Fig 1: Removing Attaching Cloth Tape
Courtesy of DAIMLERCHRYSLER CORPORATION
Remove the strips of tape one by one, making a road test after each is removed, until a wind noise source is discovered.

Fig 2: Installing Attaching Cloth Tape
Courtesy of DAIMLERCHRYSLER CORPORATION
When such a place is found, cover it again and repeat the procedure to check if there are any other noise source.
If no others are found, the last remaining tape is the only source.

Fig 3: Identifying Last Remaining Tape
Courtesy of DAIMLERCHRYSLER CORPORATION
Cut the remaining piece of tape into smaller pieces, attach it again as it was before, and then remove the pieces one by one to narrow down the source.

Fig 4: Cutting Remaining Piece Of Tape
Courtesy of DAIMLERCHRYSLER CORPORATION
Check that wind noise occurs when the last remaining tape is removed, and that noise does not occur when it is re-attached.
When the source(s) of the wind noise is finally located, attach butyl tape, body sealer or similar material to obstruct this source as much as possible.

Fig 5: Checking Wind Noise Occurs Last Remaining Tape
Courtesy of DAIMLERCHRYSLER CORPORATION