Test VER-2: Body Verification Test
WARNING: This page is about a different car, the 2001 Dodge Grand Caravan, 2001 Dodge Caravan, 2001 Chrysler Voyager, and 2001 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
Remove all test equipment and jumpers. Reconnect all previously disconnected components and connectors. Using DRB, clear all DTCs. Cycle ignition switch from ON to OFF position. If BCM was replaced, leave ignition switch in ON position for at least 15 seconds to allow NEW BCM to learn VIN. Start engine and allow to run for at least 2 minutes. Fully operate system that was malfunctioning. Turn ignition switch to OFF position and wait at least 5 seconds. Turn ignition switch to ON position. Using DRB, read DTCs. If no DTCs are displayed, repair is complete. If DTCs are displayed, go to TEST 1A: IDENTIFYING SYSTEM PROBLEMS .