LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Vehicle Theft Security System - Coupe) >> Ignition Switch >> Immobilizer System Diagnosis >> Check At Ecu Terminal

Check At Ecu Terminal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

TERMINAL VOLTAGE CHECK

Fig 1: Identifying Theft-Alarm Indicator Light
G04538867Courtesy of DAIMLERCHRYSLER CORPORATION
THEFT-ALARM INDICATOR LIGHT REFERENCE

TERMINAL NO. SIGNAL CHECKING REQUIREMENT TERMINAL VOLTAGE
3 Immobilizer-ECU ground Always 0V
5 ECM < M/T > or PCM < A/T > - -
7 Immobilizer-ECU power supply Ignition switch: "LOCK" (OFF) 0V
Ignition switch: "ON" Battery positive voltage
9 "THEFT-ALARM" indicator control "THEFT-ALARM" indicator light is not illuminated Battery positive voltage
"THEFT-ALARM" indicator light is illuminated 2 volts or less
10 Ignition key ring antenna - -
11 Ignition key ring antenna - -