LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (HVAC Systems - Coupe) >> Heater Control Assembly And A/C Switch >> Removal And Installation >> Installation Service Point >> >> A << Heater Control Assembly Installation

>> A << Heater Control Assembly Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Follow the steps below to install the air outlet changeover damper link cable.
    1. Set the air outlet changeover control knob on the heater control assembly to the defroster position.
    2. Set the air outlet changeover damper link of the heater/cooler unit to the defroster position as shown in the illustration, and then connect the cable to the link pin.
    3. Push the outer cable in the direction so that there is no looseness, and then secure it with the clip.
      Fig 1: Installing Heater Control Assembly
      G04538746Courtesy of DAIMLERCHRYSLER CORPORATION
  2. Follow the steps below to install the air mix damper lever cable.
    1. Set the temperature control knob on the heater control assembly to the maximum hot position.
    2. Set the air mix damper lever of the heater/cooler unit to the maximum hot position as shown in the illustration, and then connect the cable to the lever pin.
    3. Push the outer cable in the direction so that there is no looseness, and then secure it with the clip.
      Fig 2: Pushing Outer Cable
      G04538747Courtesy of DAIMLERCHRYSLER CORPORATION
  3. After installation, ensure that each damper operates smoothly by operating the heater control assembly knob.
scientia non olet · About LEMON Manuals