Resistor Check
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
Use an ohmmeter to measure the resistance between the terminals. Check that the measured value is at the standard value.
Standard value:
ITEM SPECIFICATION
| MEASUREMENT TERMINAL |
STANDARD VALUE Ω |
| Between terminals 3 and 2 (LO) |
2.3 |
| Between terminals 3 and 4 (ML) |
1.1 |
| Between terminals 3 and 1 (MH) |
0.4 |
Courtesy of DAIMLERCHRYSLER CORPORATION