LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Lighting Systems - Coupe) >> Headlight, Front Side Marker Light And Position Light Assembly >> On-Vehicle Service < Stratus Coupe > >> Headlight Aiming < Stratus Coupe > >> Headlight Aiming Adjustment

Headlight Aiming Adjustment

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. The low beam headlight will project on the screen upper edge of the beam (cut-off).
  2. Turn the adjusting screws to achieve the specified low-beam cut-off location on the aiming screen.
    Fig 1: Locating Adjusting Screw
    G04539497Courtesy of DAIMLERCHRYSLER CORPORATION

    Standard value: 

    (Vertical direction) Horizontal center line +/- 50 mm (+/- 2.0 inches) 

  3. When adjusting headlight, disconnect the other headlight harness.
    CAUTION: Do not cover a headlight for more than three minutes to prevent the plastic headlight lens from deformation.
  4. There is no horizontal aim adjustment. Horizontal aim is preset and does not require adjustment. High-beam pattern should be correct when the low-beams are adjusted properly.
    Fig 2: Identifying Low-Beam Cut-Off Location On Aiming Screen
    G04539498Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals