LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Lighting Systems - Coupe) >> Fog Light And Front Turn Signal Light >> On-Vehicle Service >> Fog Light Adjustment

Fog Light Adjustment

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check if the beam shining onto the screen is at the standard value.

    Standard value: 

    (Vertical direction): Top of the hot zone should be 101 mm (4.0 inches) (0.76°) downward from the height of the fog light center. 

    Limit: 

    (Vertical direction): Top of the hot zone should be 152 mm (15.24 cm) (1.14°) in maximum downward from the height of the fog light center. 

NOTE: The horizontal direction is non-adjustable. If deviation of the light beam axis exceeds the standard value, check that the mounting location or some other points are not faulty.
Fig 1: Identifying Beam Shining Onto Screen Standard Value
G04539509Courtesy of DAIMLERCHRYSLER CORPORATION
Fig 2: Identifying Adjusting Screw
G04539510Courtesy of DAIMLERCHRYSLER CORPORATION