Windshield Wiper And Windshield Washer Switch Check

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

TESTER CONNECTION & SPECIFIED CONDITION CHART

SWITCH POSITION	TESTER CONNECTION	SPECIFIED CONDITION
OFF	23 - 32, 23 - 31, 23 - 30, 21 - 23, 22 - 23	-
Windshield wiper mist switch ON	23 - 32	Less than 2 ohms
Windshield intermittent wiper switch ON	23 - 31	Less than 2 ohms
Windshield low-speed wiper switch ON	23 - 30	Less than 2 ohms
Windshield high-speed wiper switch ON	21 - 23	Less than 2 ohms
Windshield wiper switch ON	22 - 23	Less than 2 ohms

Fig 1: Checking Windshield Wiper And Windshield Washer Switch

Courtesy of DAIMLERCHRYSLER CORPORATION

Measure the resistance value at terminal numbers 27 and 28. The resistance value should rise smoothly from approximately 0 ohms ("FAST" position) to approximately 1 k/ohm ("SLOW" position).