LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Overhaul - Automatic Transmission - Coupe) >> UNDERDRIVE Clutch And Input Shaft >> Disassembly And Assembly >> Assembly Service Points >> >> C << Clutch Plate/Clutch Disc/Clutch Reaction Plate Installation

>> C << Clutch Plate/Clutch Disc/Clutch Reaction Plate Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Immerse the clutch disc in ATF before assembling it. IF the clutch disc is new, soak it in ATF for at least two hours.
  1. Assemble the four clutch plates and four clutch discs one on top of the other inside the underdrive clutch retainer. All four clutch plates should be assembled so that the places with no teeth (marked "A") are aligned with the holes in the retainer (marked "B").
  2. Install the clutch reaction plate in the direction shown. in stall it the same as the clutch plates, so that the areas with no teeth (marked "A") are aligned with the retainer (marked "B").
    Fig 1: Identifying Teeth Mark A And B
    G04539115Courtesy of DAIMLERCHRYSLER CORPORATION
    Fig 2: Identifying Clutch Reaction Plate
    G04539116Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals