LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Cruise Control Systems - Coupe) >> On-Vehicle Service >> Auto-Cruise Control System Component Check >> Clutch Pedal Position Switch

Clutch Pedal Position Switch

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the connector.
  2. Check for continuity between the terminals of the switch.
    TERMINAL CONNECTOR SPECIFIED CONDITION CHART

    MEASUREMENT CONDITIONS TERMINAL CONNECTOR OF TESTER SPECIFIED CONDITION
    When clutch pedal is depressed. 1 - 2 Less than 2 ohms
    When clutch pedal is not depressed. 1 - 2 Open circuit
    Fig 1: Disconnecting Connector
    G04539464Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals