LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Simplified Wiring System (SWS) - Coupe) >> SWS Diagnosis >> Input Signal Chart

Input Signal Chart

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

If the input signal check finds a defect, follow the table below to check.

INPUT SIGNAL CHART

SYMPTOMS INSPECTION PROCEDURE
The ignition switch (ACC) signal is not sent to the ETACS-ECU. O-1
The ignition switch (IG1) signal is not sent to the ETACS-ECU. O-2
The key reminder switch signal is not sent to the ETACS-ECU. O-3
The hazard warning light switch signal is not sent to the ETACS-ECU. O-4
The fog light switch signal is not sent to the ETACS-ECU. O-5
The washer fluid level switch signal is not sent to the ETACS-ECU. O-6
The driver's seat belt switch signal is not sent to the ETACS-ECU. O-7
The driver's or passenger's door switch signal is not sent to the ETACS-ECU. O-8
The driver's or passenger's door lock key cylinder switch signal is not sent to the ETACS-ECU. O-9
The driver's or passenger's door lock actuator switch signal is not sent to the ETACS-ECU. O-10
The door lock switch (incorporated in power window main switch and power window sub switch) signal is not sent to the ETACS-ECU. O-11
The trunk lid latch switch signal is not sent to the ETACS-ECU. O-12
The speed sensor signal is not sent to the ETACS-ECU. O-13
Column switch The taillight switch signal is not sent to the ETACS-ECU. O-14
The headlight switch signal is not sent to the ETACS-ECU.
The passing light switch signal is not sent to the ETACS-ECU.
The dimmer switch signal is not sent to the ETACS-ECU.
The turn-signal light switch signal is not sent to the ETACS-ECU.
The windshield mist wiper switch signal is not sent to the ETACS-ECU. O-15
The windshield intermittent wiper switch signal is not sent to the ETACS-ECU.
The windshield low-speed wiper switch signal is not sent to the ETACS-ECU.
The windshield high-speed wiper switch signal is not sent to the ETACS-ECU.
The windshield intermittent wiper intervals adjusting knob signal is not sent to the ETACS-ECU. O-16
The windshield washer signal is not sent to the ETACS-ECU. O-15
Transmitter The lock, unlock, trunk or panic switch signal is not sent to the ETACS-ECU. O-17
Sunroof switch The open/tilt up or close/tilt down switch signal is not sent to the ETACS-ECU. O-18
ETACS-ECU does not receive a interior light loaded signal. O-19
Check the circuit (power supply line) from the battery to the ETACS-ECU. P-1