LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Manual Transmission - Servicing) >> Removal & Installation >> Gearshift Cable >> Removal (Sebring Convertible & Stratus Sedan)

Removal (Sebring Convertible & Stratus Sedan)

WARNING: This page is about a different car, the 2002 Dodge Stratus, 2002 Dodge Neon, 2002 Chrysler Sebring, 2002 Chrysler PT Cruiser, and 2002 Chrysler Neon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull gearshift lever boot downward from bottom of gearshift lever knob on gearshift lever. Using screwdriver, pry legs on each side of gearshift lever knob from gearshift lever. Legs are located at bottom of gearshift lever knob. Remove gearshift lever knob from gearshift lever.
  2. Remove gearshift lever boot from center console by squeezing base of gearshift lever boot together. Remove 2 screws at front of center console located near gearshift lever. Remove 2 screws from rear of center console. Fully engage parking brake. Remove center console. See Figure .
  3. Disconnect crossover cable from gearshift lever assembly. See Figure . Disconnect gearshift cable from gearshift lever assembly. See Figure .
  4. Disconnect battery cables. Remove air cleaner assembly. Disconnect gearshift cables from transaxle. Figure . Raise and support vehicle. Remove cable grommet from floor pan. Remove gearshift cable assembly from vehicle.
scientia non olet · About LEMON Manuals