LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Manual Transmission - Servicing) >> Removal & Installation >> Gearshift Cable >> PT Cruiser (Removal)

PT Cruiser (Removal)

WARNING: This page is about a different car, the 2002 Dodge Stratus, 2002 Dodge Neon, 2002 Chrysler Sebring, 2002 Chrysler PT Cruiser, and 2002 Chrysler Neon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fully apply parking brake. Remove screws attaching console to floor bracket. Raise console to access wire connector. Pull gearshift lever knob upward to remove. See Figure . Lift console upward over gearshift lever assembly and parking brake handle. Remove center console from vehicle. See Figure .
  2. Disconnect crossover cable from gearshift lever assembly. See Figure . Disconnect gearshift cable from gearshift lever assembly. See Figure . Disconnect battery cables and remove battery. Remove air cleaner assembly. See Figure .
  3. Remove battery tray from bracket. Disconnect gearshift cables from transaxle. See Figure . Raise and support vehicle. Remove catalytic converter heat shield. See Figure . Remove intermediate pipe heat shield front bolts. Remove remaining grommet plate screw. See Figure . Remove gearshift cable assembly from vehicle.
scientia non olet · About LEMON Manuals