Ignition Power Transistor Continuity Check < 3.0L Engine >

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Measuring Voltage Between Ignition Power Transistor Terminals

Courtesy of DAIMLERCHRYSLER CORPORATION

NOTE: An analog-type ohmmeter should be used.

NOTE: Connect the negative probe of the ohmmeter to terminal 2.

CAUTION: This test must be performed quickly (in less than 10 seconds) to prevent coil from burning and ignition power transistor from breaking.

As described in the chart below, perform a continuity check on the ignition power transistor.

Replace the ignition power transistor if there is a malfunction.

CONTINUITY CHART

1.5 V POWER SUPPLY BETWEEN 3 - 4	CONTINUITY BETWEEN 2 - 4
Current flowing	Yes
Current not flowing	No