Magnetic Switch Pull-In Test

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the field coil wire from the M-terminal of the magnetic switch.
CAUTION: This test must be performed quickly (in less than 10 seconds) to prevent the coil from burning.
Connect a 12-volt battery between the S-terminal and M-terminal.
If the pinion moves out, the pull-in coil is good. If it doesn't, replace the magnetic switch.

Fig 1: Connecting Battery Between The S-Terminal And M-Terminal (2.4L Engine)
Courtesy of DAIMLERCHRYSLER CORPORATION

Fig 2: Connecting Battery Between The S-Terminal And M-Terminal (3.0L Engine)
Courtesy of DAIMLERCHRYSLER CORPORATION