LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Engine Cooling System - Coupe) >> On-Vehicle Service >> Fan Controller Check

Fan Controller Check

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove condenser fan motor connector.
  2. Start the engine and run it at idle.
  3. Turn the A/C switch to ON and maintain the coolant temperature at 80°C (176°F) or less.
  4. When measuring the voltage between the fan control module-side connector terminals, check that the value changes repeatedly as indicated by (1) - (3) below.
    1. 0 V
    2. 8.2 +/- 2.6 V
    3. Battery positive voltage +/- 2.6 V
  5. If the voltage does not repeatedly change as indicated, replace the radiator fan motor and the fan control module assembly. (Refer to RADIATOR  ).
    Fig 1: Measuring Voltage Between Fan Control Module-Side Connector Terminals
    G04537364Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals