Engine Coolant Leak Check
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
When pressure testing the cooling system, slowly release cooling system pressure to avoid getting burned by hot coolant.
CAUTION:
- Be sure to completely clean away any moisture from the places checked.
- When the tester is taken out, be careful not to spill any coolant from it.
- Be careful when installing and removing the tester and when testing not to deform the filler neck of the radiator.
- Check that the coolant level is up to the filler neck. Install a radiator cap tester and apply 160 kPa (23 psi) pressure, and then check for leakage from the radiator hose or connections.
- If there is leakage, repair or replace the appropriate part.