LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Clutch On-Vehicle Service - Coupe) >> On-Vehicle Service >> Clutch Interlock Switch Check And Adjustment

Clutch Interlock Switch Check And Adjustment

WARNING: This page is about a different car, the 2005 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check to be sure that the interlock switch is as shown in the illustration when the clutch pedal is depressed at its full stroke 130 mm (5.1 inch). If the specified dimension is not met, loosen the clutch interlock switch 1/4 turns counterclockwise. Then slide the switch to the specified dimension, and turn the switch 1/4 turns clockwise to lock.
    Fig 1: Identifying Clutch Interlock Switch Clearance
    G04537308Courtesy of DAIMLERCHRYSLER CORPORATION
  2. Connect an ohmmeter to the interlock switch connector, and then check for continuity when the clutch pedal is fully depressed and when it is released outward.
    TESTER CONNECTION & SPECIFIED CONDITION CHART

    PEDAL POSITION TESTER CONNECTION SPECIFIED CONDITION
    FULLY DEPRESSED 1 - 2 Less than 2 ohms
    RELEASED 1 - 2 Open circuit
    Fig 2: Checking Clutch Interlock Switch
    G04537309Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals