Special Tools
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOLS
| TOOL | TOOL NUMBER AND NAME | REPLACED BY MILLER TOOL NUMBER | APPLICATION |
|---|---|---|---|
| MB990767 Front hub and flange yoke holder | C-3281 | Hub fixing | |
| MB991618 Hub bolt remover | C-4150A | Driving out of hub bolt | |
| MB991897 Ball joint remover | MB991113 | Knuckle and tie rod end ball joint disconnection
NOTE:
Steering linkage puller (MB990635 or MB991113)is also used to disconnect knuckle and tie rod end ball joint.
|
|
| MB990998 Front hub remover and installer | MB990998 |
|
|
| MB990326 Preload wrench | N/A | Wheel bearing breakaway torque measurement | |
| MB990241 Axle shaft puller A: MB990242 Puller shaft B: MB990244 Puller bar |
N/A | Drive shaft removal | |
| MB991354 Puller body | N/A | Drive shaft removal | |
| MB991248 Inner shaft remover | P-334 | Inner shaft removal | |
| MB991172 Inner shaft installer base | General service tool | Inner shaft installation | |
| MB990925 Bearing and oil seal installer set | 8615 8616 8617 C-4171 |
|
|
| MB990890 Rear suspension bush base | 8619 | Oil seal installation | |
| MB991561 Boot band crimping tool | C-4975A | Resin boot band installation | |
| A | MB990926 | 39.0 (1.54) | |
| MB990927 | 45.0 (1.77) | ||
| MB990928 | 49.5 (1.95) | ||
| MB990929 | 51.0 (2.00) | ||
| MB990930 | 54.0 (2.13) | ||
| MB990931 | 57.0 (2.24) | ||
| MB990932 | 61.0 (2.40) | ||
| MB990933 | 63.5 (2.50) | ||
| MB990934 | 67.5 (2.66) | ||
| MB990935 | 71.5 (2.81) | ||
| MB990936 | 75.5 (2.97) | ||
| MB990937 | 79.0 (3.11) | ||
| B | MB990938 | - | |
| C | MB990939 | - |