Removal And Installation: Notes
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- For vehicles with ABS, be careful when handling the projection at the tip of the speed sensor so as not to damage it by striking against other parts.
- The front hub assembly should not be dissembled. When removing the front hub assembly, the wheel bearing inner race may be left at the spindle side. In this case, always replace the front hub assembly, otherwise the hub will damage the oil seal, causing oil leaks or excessive play.
Required Special Tools:
- MB990326: Preload Wrench
- MB990767: Front Hub and Flange Yoke Holder
- MB990998: Front Hub Remover and Installer
- MB991897: Ball Joint Remover