INSPECTION PROCEDURE 1: Noise during Wheel Rotation: Diagnosis
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
- STEP 1. Check the driveshaft and inner shaft for bending.
Q: Is the driveshaft and inner shaft bent?
YES : Replace the part. Then go to Step 4.
NO: Go to Step 2.
- STEP 2. Check the inner shaft bearing for wear.
Q: Is the inner shaft bearing worn?
YES : Replace the bearings. Then go to Step 4.
NO: Go to Step 3.
- STEP 3. Check the driveshaft assembly for wear, damage or bending.
Q: Is the driveshaft assembly worn, damaged or bent?
YES : Replace the driveshaft assembly. Then go to Step 4.
NO: There is no action to be taken.
- STEP 4. Retest the system.
Q: Is the abnormal noise eliminated?
YES : The procedure is complete.
NO: Repeat from Step 1.