LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Front Axle - Coupe) >> Drive Shaft Assembly >> Disassembly And Assembly >> Assembly Service Points >> >> A << Dynamic Damper/Damper Band/TJ Boot Installation

>> A << Dynamic Damper/Damper Band/TJ Boot Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the dynamic damper in the position shown in the illustration.
    DYNAMIC DAMPER REFERENCE

    ITEM LH RH
    A mm (in) 242 +/- 3 (9.5 +/- 0.12) 254 +/- 3 (10.0 +/- 0.12)
    CAUTION:
    • There should be no grease adhered to the rubber part of the dynamic damper.
    • The damper band and the TJ boot band (small) are different in shape. Be careful not to assemble a wrong band by identifying a color of the band.
      Fig 1: Installing Dynamic Damper Band TJ Boot
      G04537019Courtesy of DAIMLERCHRYSLER CORPORATION
  2. Secure the damper bands.
    DAMPER BANDS SPECIFICATION

    ITEM BAND COLOR
    Damper band Blue
    TJ boot band Silver
  3. Wrap plastic tape around the shaft spline, and then install the TJ boot band (small) and TJ boot.
scientia non olet · About LEMON Manuals