LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (3.0L Engine - On-Vehicle Service - Coupe) >> Timing Belt >> Removal And Installation >> Removal Service Points >> << B >> Timing Belt Removal

<< B >> Timing Belt Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Never turn the crankshaft counterclockwise.
  1. Turn the crankshaft clockwise to align each timing mark and to set the number 1 cylinder to compression top dead center.
  2. If the timing belt is to be reused, chalk an arrow on the flat side of the belt, indicating the clockwise direction.
  3. Loosen the center bolt of the tensioner pulley, then remove the timing belt.
    Fig 1: Loosening Center Bolt Of Tensioner Pulley
    G04538391Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals