Special Tools
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOLS
| TOOL | TOOL NUMBER AND NAME | REPLACED BY MILLER TOOL NUMBER | APPLICATION |
|---|---|---|---|
| MB991502 Scan tool (MUT-II) |
DRB-III Used with CH8425 |
|
|
| MB991668 Belt tension meter set |
N/A | Drive belt tension check (used together with scan tool < MUT-II >) | |
| MB991453 Engine hanger attachment set |
C-4852 | When an engine lifer is used: Supporting the engine assembly during remove and installation of the transaxle (Use with MZ203827 and MB991453) | |
| GENERAL SERVICE TOOL MZ203827 Engine lifter |
N/A | ||
| MB991454 Engine hanger balancer |
N/A | When the engine hanger is used: Supporting the engine assembly during remove and installation of the transaxle
NOTE:
Special tool MB991454 is a part of engine hanger attachment set MB991453.
|
|
| MB991895 Engine hanger |
N/A | ||
| MB991928 Engine hanger A: MB991929 Joint (50) x2 B: MB991930 Joint (90) x2 C: MB991931 Joint (140) x2 D: MB991932 Foot (standard) x4 E: MB991933 Foot (short) x2 F: MB991934 Chain and hook assembly |
N/A | ||
| MD998443 Lash adjuster holder (8) |
MD998443 | Supporting of the lash adjuster to prevent it from falling when rocker shaft assembly is removed or installed | |
| MB990767 End yoke holder |
6847 Use with C-3281 |
Holding the camshaft sprocket and crankshaft pulley when loosening and tightening bolt (Use with MD998715) | |
| MD998715 Crankshaft pulley holder pin |
C-3281 | Holding the camshaft sprocket and crankshaft pulley when loosening and tightening bolt (Use with MB990767) | |
| MD998713 Camshaft oil seal installer |
MD998713 Used with 8618 screw |
Camshaft oil seal installation | |
| MB991559 Camshaft oil seal installer adapter |
6863 | Camshaft oil seal installation (left bank side) (Use with MD998713) | |
| MD998717 Crankshaft front oil seal installer |
MD998717 | Crankshaft front oil seal installation | |
| MD998781 Flywheel stopper |
N/A | Flywheel < M/T > or drive plate < A/T > supporting | |
| MD998718 Crankshaft rear oil seal installer |
MD998718 | Crankshaft rear oil seal installation | |
| MD998051 Cylinder head bolt wrench |
N/A | Cylinder head bolt loosening and tightening | |
| MD998767 Tensioner pulley socket wrench |
MD998767 | Timing belt tension adjustment | |
| MD998769 Crankshaft sprocket spacer |
N/A | Used if the crankshaft needs to be rotated to attach the timing belt, etc. |