LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (3.0L Engine - On-Vehicle Service - Coupe) >> Cylinder Head Gasket >> Removal And Installation >> Installation Service Points >> >> B << Cylinder Head Assembly Installation

>> B << Cylinder Head Assembly Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Be careful that no foreign material gets into the cylinder, coolant passages or oil passages. Engine damage may result.
  1. Use a scraper to clean the gasket surface of the cylinder head assembly.
    CAUTION: Attach the cylinder head bolt washer in the direction shown in the illustration.
  2. Using special tool MD998051 and a torque wrench, tighten the bolts to the specified torque in the order shown in the illustration. (in two or three steps)

    Tightening torque: 108 +/- 5 N.m (80 +/- 3 ft-lb) 

  3. Loosen the mounting bolts in the reverse sequence to that shown.
  4. Tighten the mounting bolts progressively in the shown sequence to the specified torque again.

    Tightening torque: 108 +/- 5 N.m (80 +/- 3 ft-lb) 

    Fig 1: Loosening Mounting Bolts In Reverse Sequence
    G04538388Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals