<< C >> Transaxle Assembly Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Do not remove the flywheel mounting bolt shown by the arrow. If this bolt Is removed, the flywheel will become out of balance and damaged.

< Engine lifter MZ203827 is used >
Remove the transaxle assembly.

< M/T >: Refer to TRANSAXLE ASSEMBLY .

< A/T >: Refer to TRANSAXLE ASSEMBLY .

Fig 1: Identifying Flywheel Mounting Bolt
Courtesy of DAIMLERCHRYSLER CORPORATION
< Engine hanger MB991895 or MB991928 is used >
1. Loosely fit the two radiator support upper insulator mounting bolts to the vehicle body.
2. Remove the transaxle assembly.
< M/T >: Refer to TRANSAXLE ASSEMBLY .

< A/T >: Refer to TRANSAXLE ASSEMBLY .

Fig 2: Identifying Radiator Support Upper Insulator Mounting Bolts
Courtesy of DAIMLERCHRYSLER CORPORATION