LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (2.4L Engine - On-Vehicle Service - Coupe) >> Engine Assembly >> Removal And Installation >> Installation Service Points >> >> D << Fuel High-Pressure Hose Installation

>> D << Fuel High-Pressure Hose Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not allow any engine oil to enter the fuel rail.
  1. Apply a small amount of new engine oil to the O-ring.
  2. While turning the fuel high-pressure hose to the right and left, install it to the fuel rail, while being careful not to damage the O-ring. After installing, check that the hose turns smoothly.
  3. If the hose does not turn smoothly, the O-ring is probably being clamped. Disconnect the fuel high-pressure hose and check the O-ring for damage. Replace if necessary.
  4. Re-insert the fuel rail and confirm the hose turns smoothly.
    Fig 1: Applying Small Amount Of New Engine Oil To O-Ring
    G04538142Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals