LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Lubrication & Maintenance- Coupe) >> Maintenance Service >> 22. SRS Air Bag (Inspect System) >> Front Seatback Assembly With Side-Airbag Module >> Notes

Front Seatback Assembly With Side-Airbag Module: Notes

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • If any improper part is found during the following inspection, replace the front seatback assembly with a new one.
  • Dispose of the old one according to the specified procedure. (Refer to , AIR BAG MODULE DISPOSAL PROCEDURES .)
  • Never attempt to measure the circuit resistance of the air bag module (squib) even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental air bag deployment will result in serious personal injury.
  1. Check the air bag module deployment section for dents or deformation.
  2. Check the connector for damage; check the terminals for deformation; and check the harness for binding.
    Fig 1: Checking Air Bag Module Deployment Section
    G04536911Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals