Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSIS PROCEDURE - P1790-FAULT IMMEDIATELY AFTER SHIFT
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 |
NOTE:
Low fluid level can be the cause of many transmission problems. If the fluid level is low locate and repair the leak then check and adjust the fluid level per the Service Information.
NOTE:
Always perform diagnostics with a fully charged battery to avoid false symptoms. With the DRBIII®, read Engine DTC's. Check and repair all Engine DTC's prior to performing any transmission symptom diagnostics.With the DRBIII®, read Transmission DTC's. Record all DTC's and 1 Trip Failures.
NOTE:
Diagnose 1 Trip Failures as a fully matured DTC. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.Repair as necessary.Perform the Shift Lever Position Test. If the test does not pass, refer to P0706 CHECK SHIFTER SIGNAL .For Gear Ratio DTC's, check and record all CVI's.Most DTC's set on start up but some must be set by driving the vehicle such that all diagnostic monitors have run.
NOTE:
Verify flash level of Powertrain Control Module. Some problems are corrected by software upgrades to the Transmission and Engine software.
NOTE:
Check for applicable TSB's related to the problem. Perform this procedure prior to Symptom diagnosis.ContinueGo To 2 |
All |
| 2 | This test is set along with a gear ratio DTC. Perform the appropriate test for the Gear Ratio DTC stored.
NOTE:
Check 1 trip failures if there are no gear ratio DTCs current. If there are no possible causes remaining, view repair. Repair Perform the appropriate symptom. Perform 40/41TE (NGC) TRANSMISSION VERIFICATION TEST - VER 1 . |
All |