LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Chassis Diagnostic Procedures - Anti-Lock Brake System) >> Diagnostic Information And Procedures >> Brakes (25E) - Symptoms >> Symptom: INSTRUMENT CLUSTER BULB >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
INSTRUMENT CLUSTER BULB SYMPTOM CHART

TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRBIII®, read DTCs.
Are there any Instrument Cluster or ABM DTCs present?
Yes --> Refer to the appropriate category for the related symptom(s).
Perform ABS VERIFICATION TEST - VER 1 .
No --> Go To 2
All
2 Turn the ignition off.
Perform the Key-on Bulb Check.
Does the ABS, Brake, or TCS (if equipped) indicators light and then go out after four seconds?
Yes --> Go To 3
No. Light remains after bulb check.
Go To 4
No. Indicator never came on.
Go To 5
All
3 Turn the ignition off.
Turn the ignition on.
With the DRBIII®, record and erase DTC's.
NOTE: If you have other DTCs, repair other DTCs first before continuing.

Turn the ignition off.
Remove ABS Valve fuse.
Perform the Key-on Bulb Check.
Does the ABS, Brake, and TCS (if equipped) Indicators remain on after the 4 second bulb check?
Yes --> Reinstall the ABS Valve fuse. With the DRBIII®, erase Instrument Cluster DTCs. Test Complete.
Perform ABS VERIFICATION TEST - VER 1 .
No --> Go To 4
All
4 Reinstall the ABS Valve fuse, if removed.
Turn the ignition off.
Turn the ignition to RUN.
Perform the self test.
NOTE: Refer to Body information for the related test(s).

Did the indicators illuminate during the Instrument Cluster self test?
Yes --> Replace the Anti-Lock Brake module in accordance with the Service Information.
Perform ABS VERIFICATION TEST - VER 1 .
No --> Go To 5
All
5 Turn the ignition off.
Turn the ignition to RUN.
Perform the self test.
NOTE: Refer to Body information for the related test(s).

Do the indicators turn on for 4 seconds, shut off for 5-10 seconds then illuminate?
Yes --> Test Complete.
No --> Ensure the ABS indicator bulb is installed or good in the Instrument Cluster. If verified working, replace the Instrument Cluster in accordance with the Service Information.
Perform ABS VERIFICATION TEST - VER 1 .
All