LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Body Diagnostic Procedures - Except Coupe) >> Diagnostic Information And Procedures >> Power Top >> Symptom: *FOUR WINDOW DROP INOPERATIVE >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - DECKLID SWITCH DISARM FAILURE

TEST ACTION APPLICABILITY
1
NOTE: Ensure the power windows are operating properly from the master switch before proceeding.
Turn the ignition on.With the DRBIII®, read DTCs.Does the DRBIII® display any POWER TOP SWITCH - DTC's?No --> Go To 2Yes --> Refer to POWER TOP SWITCH .Perform BODY VERIFICATION TEST - VER 1 .		 All
2 Prepare the vehicle for the top to operate.
With the DRBIII®, read the CONVERT TOP SW voltage
Press the Top Switch to the second detent and observe the voltage.
Is the voltage between 1.6 and 2.2 volts when the switch is pressed?
Yes --> Go To 3
No --> Replace the Power Top Switch.
Perform BODY VERIFICATION TEST - VER 1 .		 All
3 Disconnect the Window Drop Relay Assembly connector.
Turn the ignition on.
Using a 12-volt test light connected to ground, check all Fused Ignition Switch
Output circuits.
Does the test light illuminate brightly on all circuits?
Yes --> Go To 4
No --> Using the schematic as a guide, repair the Fused Ignition Switch
Output circuit(s) for an open.
Perform BODY VERIFICATION TEST - VER 1 .		 All
4 Disconnect the Window Drop Relay Assembly connector.
Disconnect the Body Control Module C4 connector.
Turn the ignition off.
Measure the resistance of the Window Down Relay Control circuit between the Window Drop Relay Assembly connector and the BCM C4 connector.
Is the resistance below 5.0 ohms?
Yes --> Go To 5
No --> Repair the Window Down Relay Control circuit for an open.
Perform BODY VERIFICATION TEST - VER 1 .		 All
5 Disconnect the Body Control Module C4 connector.
Turn the ignition on.
Momentarily connect a jumper wire between ground and the Window Down Relay
Control circuit in the BCM C4 connector.
Did all four windows go down when the wire was grounded?
Yes --> Go To 6
No --> Replace the Window Drop Relay Assembly.
Perform BODY VERIFICATION TEST - VER 1 .		 All
6 If there are no possible causes remaining, view repair.
Repair
Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals