Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - ALL DOORS FAILING TO LOCK FROM ANY SWITCH
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Disconnect the Body Control Module C4 connector. Measure the resistance between ground and any Lock Relay Output circuits in the BCM C4 connector.. Is the resistance below 1000.0 ohms (should be infinite)? Yes --> Repair the Lock Relay Output circuits as necessary. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 2 |
All |
| 2 | If there are no possible causes remaining, view repair Repair Replace the Body Control Module. Perform BODY VERIFICATION TEST - VER 1 . |
All |