Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - COURTESY LAMP INOPERATIVE - ALL LAMPS
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Gain access to the junction block C10 Harness connector but do not disconnect. While back probing, measure the voltage of the Fused B+ circuit. Is the voltage above 10.0 volts? Yes --> Go To 2 No --> Replace the Junction Block Perform BODY VERIFICATION TEST - VER 1 . |
All |
| 2 | Check Junction Block Fuse 5 Is Fuse 5 open? Yes --> Replace the open fuse. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 3 |
All |
| 3 | Back probe a jumper wire from the Courtesy Lamps Driver circuit to the Junction Block C10 connector and ground. Do the courtesy lamps come on? Yes --> Replace the Body Control Module. Perform BODY VERIFICATION TEST - VER 1 . No --> Repair the open Courtesy Lamp Driver circuit. Perform BODY VERIFICATION TEST - VER 1 . |
All |