LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Body Diagnostic Procedures - Except Coupe) >> Diagnostic Information And Procedures >> Instrument Cluster >> Symptom: *VTSS INDICATOR INOPERATIVE >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - VTSS INDICATOR INOPERATIVE

TEST ACTION APPLICABILITY
1
NOTE: Verify the vehicle is equipped with VTSS/SKIM.
NOTE: Ensure that the VTSS is enabled before proceeding with this test.
NOTE: Observe the VTSS indicator during the Bulb Check. If the indicator does not illuminate, replace the Instrument Cluster.
Turn the ignition on.With the DRBIII®, read Body Control Module / SKIM DTCs.Does the DRBIII® display any DTCs?Yes --> Refer to the VEHICLE THEFT / SECURITY category  and perform the appropriate symptom.Perform BODY VERIFICATION TEST - VER 1 .No --> Go To 2		 All
2 Turn the ignition off.
Disconnect the BCM C1 harness connector.
Measure the voltage between the VTSS Indicator Driver circuit and ground.
Is the voltage above 10.5 volts?
Yes --> Replace and program the Body Control Module in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Go To 3		 All
3 Turn the ignition off.
Disconnect the Instrument Cluster Harness connector.
Disconnect the BCM C1 harness connector.
Measure the resistance of the VTSS Indicator Driver circuit.
Is the resistance above 5.0 ohms?
Yes --> Repair the VTSS Indicator Driver circuit for an open.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Replace the Instrument Cluster in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals