LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Body Diagnostic Procedures - Except Coupe) >> Diagnostic Information And Procedures >> Instrument Cluster >> Symptom: *TRACTION CONTROL INDICATOR ALWAYS ON >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - TRACTION CONTROL INDICATOR ALWAYS ON

TEST ACTION APPLICABILITY
1
NOTE: With the DRBIII®, check for any DTCs in the CAB before proceeding.
Make necessary repairs.Turn the ignition off.Disconnect the Traction Control Switch harness connector.Turn the ignition on.
NOTE: Wait approximately 10 seconds for the Instrument Cluster bulb check sequence to finish.
Observe the Traction Control Indicator.Is the Traction Control Indicator illuminated?Yes --> Go To 2No --> Replace the Traction Control Switch in accordance with the Service Information.Perform BODY VERIFICATION TEST - VER 1 .		 All
2 Turn the ignition off.
Disconnect the Traction Control Switch harness connector.
Disconnect the Instrument Cluster harness connector.
Measure the resistance between ground and the Traction Control Switch Sense circuit.
Is the resistance below 5.0 ohms?
Yes --> Repair the Traction Control Switch Sense circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Replace the Instrument Cluster in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals